General 700 Series Instructions; Display Icons 700 Controller - Autotrol 255 Manuel D'utilisation

GENERAL 700 SERIES INSTRUCTIONS

Display Icons 700 Controller

Figure 17
NOTE: In normal operation and during programming, only a few of the icons
will actually be displayed.
1. Days of the week. The flag immediately below the day will appear when that day has been
programmed as a day the system should regenerate (used with 7-day timer programming).
2. See #3
3. This cursor is displayed when the days between regeneration are being programmed
(used with .5 to 99 day regeneration programming).
4. One of these cursors will be displayed to indicate which day will be programmed into the
controller.
5. "PM" indicates that the time displayed is between 12:00 noon and 12:00 midnight (there
is no AM indicator). PM indicator is not used if clock mode is set to 24-hour.
6. When "MIN" is displayed, the value entered is in minute increments.
7. When g/L is displayed, the value for regenerant amount entered is in grams/Liter.
8. When "Kg" is displayed, the value entered is in kilograms or kilograins.
9. Four digits used to display the time or program value. Also used for error codes.
10. Colon flashes as part of the time display. Indicates normal operation (742 only).
11. Locked/unlocked indicator. In Level I programming this is displayed when the current
parameter is locked-out. It is also used in Level II programming to indicate if the displayed
parameter will be locked (icon will flash) when controller is in Level I.
12. When "x2" is displayed, a second regeneration has been called for.
13. The recycle sign is displayed (flashing) when a regeneration at the next time of regenera-
tion has been called for. Also displayed (continuous) when in regeneration.
14. The display cursor is next to "SALT" when programming the amount of regenerant. If the
controller is on a 3-cycle filter then backwash time is programmed.
15. The display cursor is next to "REGEN TIME & DAY" when programming the time of
regeneration and the days of regeneration.
16. The display cursor is next to "TIME & DAY" when programming the current time and day.
17. The hourglass is displayed when the motor is running. The camshaft should be turning.
18. These cursors will appear next to the item that is currently displayed.
19
En