Inspections According To Din En 60204-1 - Kemper MiniFil Notice De Montage

DANGER
Any work on the electrical equipment of the product must only be performed by a
qualified electrician or by trained personnel under the direction and supervision of
a qualified electrician in accordance with electronic regulations!
Before opening the product, pull the plug, if available, and secure it against
accidental switch-on.
For faults with the product's electrical energy supply, immediately switch the
product off at the on/off switch and if available, also pull the plug!
Use only original fuses with the prescribed amperage!
Electrical components, on which inspection, maintenance and repair work must be
carried out, must be disconnected from the power supply. Secure equipment that
has been used for disconnection against unintentional or automatic reconnection.
Firstly check that no voltage is present in activated, electrical components, then
isolate adjacent components under voltage. When making repairs, ensure that
constructive characteristics are not altered in a way that reduces safety.
Check cables regularly for damage and replace if necessary.

1.7 Inspections according to DIN EN 60204-1

WARNING
If any part of the product and its associated equipment is replaced or
supplemented, that part shall, as far as is feasible, be rechecked and tested.
1502806-00 - 22 -
EN