• Unscrew the LED-HL [≈H7] heat sink from the lamp.
• Adjust the installation angle of the central plate.
(1). If the angle of the halogen lamp is vertical in the optic, there is
no requirement to adjust the angle of the LED central plate.
Otherwise, it is required to adjust the installation angle of the
central plate for the LED-HL [≈H7] lamp.
(2). Use the Allen key to loosen the three set screws of the central
plate as is shown below.
(3). Turn the central plate until the LED burner is aligned vertically in
the reflector, with the LEDs shining to the left and the right, as
shown on below picture (see the hollow arrows in the following
figure) and that the LED shines toward the right and the left sides
of the reflector. Then, fasten the screws for the central plate.
8