4
Pre-installation Information
• Check to make sure that the inside diameter of the air-tight cover
for your lamp is at least 60 mm. If it is too small, there is the risk
of unsuccessful installation of the heat sink and the control box.
• The LED-HL [≈H7] lamp is not for use with all types of cars.
Please consult a professional sales representative.
• Please have a technician at a professional service location install
the LED-HL [≈H7] lamp.
• If it is found, after the LED-HL [≈H7] lamp is installed, that there is
no cut-off line for the low-beam light pattern, please switch back
to your previous halogen H7 lamp.
• Applicable car types: Please refer to the overview of applicable cars.
6
Min60mm
Figure-1