Pioneer AVH-P5200DVD Manuel D'installation page 5

Connecting the units
(2 ft. 7 in.)
80 cm
26 pin cable (Supplied with Navigation unit)
Insert the 26 pin cable in the direction
indicated in the figure.
Connection method
Note:
· The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking
brake. This lead must be connected to the power
supply side of the parking brake switch.
Blue/white
Connect to system control terminal of the power amp or
auto-antenna relay control terminal (max. 300 mA 12 V DC).
With a 2 speaker system, do not connect anything to the speaker leads
that are not connected to speakers.
Note:
· Change the initial setting of this unit (refer
to the Operation Manual). The subwoofer
output of this unit is monaural.
Tuner box (supplied)
IP-BUS cable
1. Clamp the lead.
Antenna input
Antenna cable (supplied)
Pioneer IP-BUS
accessories
Navigation unit
(AVIC-U220 (sold
separately)).
Please contact your dealer to inquire
about the connectable navigation unit.
2. Clamp firmly with
needle-nosed pliers.
Power supply side
Ground side
(2 ft. 7 in.)
80 cm
Parking brake
switch
5