Din Rear-Mount; Removing The Unit; Fastening The Front Panel - Pioneer AVH-P5200DVD Manuel D'installation

Installation
2. Install the unit into the dashboard.
Insert the mounting sleeve into the
dashboard. And then secure the mounting
sleeve by using a screwdriver to bend the
metal tabs (90°) into place.
Dashboard
182
53
Mounting sleeve
Side bracket
Screw (2 mm × 3 mm)

DIN Rear-mount

1. Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
• When installing in a shallow space, use the
following screw holes.
*1 Use binding screws (4 mm × 3 mm) only.
*1
*1
2. Tighten two screws on each side.
Use any of binding screws (4 mm × 3 mm),
binding screws (5 mm × 6 mm) or flush
surface screws (5 mm × 6 mm), depending
on the shape of screw holes in the bracket.
10
Factory radio mounting
bracket

Removing the unit

Extend top and bottom of the trim ring
outwards to remove the trim ring. And then
loosen the screws (2 mm × 3 mm) to remove
the mounting sleeve.
• When reattaching the trim ring, push the
trim ring onto the unit until it clicks after
reattaching the mounting sleeve. (If the trim
ring is attached upside down, the trim ring
will not fit properly.)
Mounting sleeve
Screw (2 mm × 3 mm)

Fastening the front panel

If you do not plan to detach the front panel,
the front panel can be fastened with supplied
screw.
Screw
Screw
Dashboard or
Console
Trim ring