Electrical Connection Diagram - Astralpool QUADRALED Manuel D'installation Et D'entretien

Automatic colour sequence:: Selection from among nine programmes of colour sequences. Each programme is defined by
the duration of each colour and of the transition from one colour to another, according to the following table:
SEQUENCE
1 Red Green
2
Cyan Purple
Emerald
3 Green
green
4 Red Orange
5 Red Magenta
6 Red Orange
Pale
7 Purple
Violet
8 Red Green

5.2.3. Electrical connection diagram

In both TOP and ECO configurations, two cables should be connected in the two 12VCA terminals of the feeder in parallel
with any spotlight (12 V Mains), as if it were another ColorPlus spotlight.
The feeder will therefore interpret the signal received and will perform the same functions as the ColorPlus spotlights.
To control the projectors with a modulator receiver and/or remote control, connect the synchronism cable from the output of
a 12V transformer to the feeder. The 12V of the transformer itself can feed large projectors (if there are any), or the 12V of
a 50W transformer or more, in cases of installations with QUADRALED projectors only.
** Attention: The pushbutton of the feeder has operation priority and should be disconnected if used jointly with the
ColorPlus series of spotlights. If it is not disconnected, the spotlights will not work correctly.
1 Red
2 Green
3 Blue
4 Yellow
5 Cyan
6 Purple
Blue
Yellow
Sky- Sky-
Cyan Blue
blue blue
Green Naranja
Blue Magenta
Green Cyan Blue Magenta
Cyan Yellow White Yellow
Blue Yellow Cian Purple
6
7 Sky-blue
8 Pale Violet
9 Orange
10 Magenta
11 Emerald green
12 White
Emerald
Cian
green
Cyan Purple
Pale Sky-
Orange Magenta
Violet blue
Remote Control
(optional)
Emerald
White
green