Electrical Connection Diagram; Operation Modes - Astralpool 27819 Manuel D'installation

4. ASSEMBLY:
The floodlamp is supplied with 2,5 m of cable (No. 16). It should be inserted through the conduit body (Fig. 4), leaving
approximately 1.50 m of cable in order to be able to remove the floodlamp to the border of the swimming pool if handling or lamp
change is required (Fig. 3).
Wind the cable in counter-clockwise direction under the screen fastening clamps.
Firmly secure the gland seal nut (No. 22) (Fig. 11).
In order to secure the floodlamp to the crosshead mount, ensure that the word "TOP" is located on the upper part. First, insert the
lower clamp of the screen in the crosshead mount.
Then, press on the upper part until the floodlamp is firmly inserted in the crosshead mount.
5. MAINTENANCE:
This projector does not require any type of maintenance. If the projector does not work properly, please contact our customer
attention department.
It is forbidden to handle the inside of the projector. All projectors which have been handled will lose their guarantee.
This projector does not need any type of maintenance.
If you wish to remove the projector from the swimming pool, it must be done by suitably qualified technician.
To remove the floodlamp to the border of the swimming pool (Fig. 3), insert a screwdriver through the upper hole of the ornament and
press on the spline of the mount until the floodlamp is released (Fig. 6).
Extracting the screw No. 21 as it is indicated in the Fig. 7. Next to throw up of the projector until it releases of the inferior fitting and
it can be extracted from the swimming pool.
Attention:
Before any handling ensure that there is NO voltage supplied to the floodlamp.
6. CONTROL SYSTEMS OF THE LED PROJECTORS:
The LED projectors can be controlled in two different ways: either by a normally closed pushbutton or by means of the modulator
receiver and/or remote control
In both cases, you should make sure that the voltage received by the lamp is never more than 12V.
The projector should only be operated underwater and anchored to the vertical walls of the pool. The spotlight is supplied with heat
protection, which in the event of excess temperature reduces the lighting level to avoid overheating.
6.1. Colorplus ECO: pushbutton control
The system has 14 operation modes: 7 set colours and 7 sequences of different colours (see section 6.1.2.) The colour or sequence
is changed by a quick press of the pushbutton. The projector/s is/are placed in white if the pushbutton is pressed for longer.

6.1.1. Electrical connection diagram

The Colour Plus Eco system is composed of the projector/s, the transformer and the normally closed (NC) pushbutton.
The transformer must be able to supply 45VA for each led spotlight connected. For example, if you want to control 6 spotlights, you
must connect them in parallel to a transformer of at least 270VA. The pushbutton must be able to withhold the power consumed by
the number of projectors installed.

6.1.2. Operation modes

The Colorplus ECO unit enables different light scenarios to be created inside the swimming pool with two operation possibilities:
Set colour: Selection of one set colour out of seven possibilities.
COLOUR Nº
1
2
3
4
5
6
7
Automatic sequence of colours: Selection of nine colour sequence programmes. Each programme is defined by the lighting time of
each colour and the transition time from one colour to another according to the following table:
% RED % BLUE % GREEN
100 100 100
100 0
0 100
0 0 100
100 100
0 100 100
100 0 100
COLOUR
White
0 Red
0 Blue
Green
0 Purple
Cyan
Yellow