Maintenance; General; Daily Cleaning; Replacing Display Light Bulbs - Hatco GLO-RAY GRAIH Série Manuel D'installation Et D'utilisation

MAINTENANCE

General

Glo-Ray Infra-Black Strip Heaters are designed for maximum
® ®
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAzARD:
• Turn power OFF at fused disconnect switch/circuit
breaker and allow unit to cool before performing any
maintenance, adjustments, or cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
414-671-6350; fax 414-671-3976.
Use only Genuine Hatco Replacement Parts when service
is required. Failure to use Genuine Hatco Replacement
Parts will void all warranties and may subject operators of
the equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco Replacement Parts
are specified to operate safely in the environments in which
they are used. Some aftermarket or generic replacement
parts do not have the characteristics that will allow them
to operate safely in Hatco equipment.

Daily Cleaning

To preserve the finish of the Glo-Ray Infra-Black Strip Heater, it
is recommended that all surfaces be cleaned daily.
NOTICE
Use non-abrasive cleaners only. Abrasive cleaners could
scratch the finish of the unit, marring its appearance and
making it susceptible to soil accumulation.
1. Turn off the unit and allow the unit to cool.
2. Wipe down all metal surfaces with a clean, damp cloth.
Stubborn stains may be removed with a good stainless
steel or non-abrasive cleaner. Clean hard to reach areas
using a small brush and mild soap.

Replacing Display Light Bulbs

Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are specifically
designed for food holding areas. Breakage of light bulbs
not specially coated could result in personal injury and/or
food contamination.
The display light is an incandescent bulb that illuminates the
warming area. This bulb has a special coating to guard against
injury and food contamination in the event of breakage.
To replace a light bulb:
1. Disconnect the power supply and wait until the unit has
cooled.
2. Unscrew the light bulb from the unit and replace it with a
new, specially-coated incandescent light bulb.
NOTE: Hatco shatter-resistant light bulbs meet NSF standards
for food holding and display areas. For 120, 120/208,
and 120/240 volt applications, use Hatco P/N
02.30.043.00. For 220–240 volt applications, use Hatco
P/N 02.30.058.00.
NOTE: Halogen bulbs are available as an option. For 120,
120/208, and 120/240 Volt applications, use Hatco P/N
02.30.081.00.
16
English
WARNING
Form No. GRaIHm-0815