sylvac UL 4 Mode D'emploi page 12

5. Favourite key
The «favourite» key gives direct access to a predefined function, and can be
configured according to the needs of the user.
In order to assign a function to the «favourite» key, give a prolonged press on
and then select the required function :
Data transmission
0 dAtA
(default)
1 HoLd
Hold display
Clear Min-Max-
2 CLr
Delta
Zero reset
3 SEt
Preset
(min.-max. mode)
4 rEF
REF1 - REF2 -
AUTO
Validation of selection: By a prolonged press on
Note : a function can also be assigned by software. (see chap. 9)
6. Adjustment and use of IntE dynamic measuring mode
Certain applications need to adjust the instrument to the MIN (or MAX) measured
value. In this case, proceed as follows :
6.1 Adjustment of the instrument
•
In REF1, enter a Preset value corresponding to the actual size of the standard.
•
Within IntE menu, choose the +AMIN mode (set DIR- and MIN mode) or
+AMAX mode (set DIR+ and MAX mode) depending on the measuring case.
Make a standard measurement (going through the turnaround point)
•
Adjust the instrument by selecting the SEt menu and pressing on the button
•
The instrument is adjusted and ready to measure.
5 PrE
Recall Preset
6 ModE
Nor–Min–Max-Delta
7 IntE OFF - +AMIN -
+AMAX
8 toL
Tol ON–Tol OFF
Bluetooth
9 bt
OFF (depends on
model)
12
10 Unit
11 dir
12 Mul
13 no.F
ON-
®
, or a press on
mm – IN
Measurement
direction, positive -
negative
Multiplier ON-OFF
no function
or
SET MODE