sylvac UL 4 Mode D'emploi page 15

10. Connecting the instrument
The instrument can be connected to a
peripheral via a Proximity (RS or USB) or
Bluetooth . (See chap. 1)
®
Measured values can be transmitted and the
instrument driven using predefined com-
mands (see chap. 11 for a list of the main
commands)
11. List of the main commands
Selection and configuration
CHA+ / CHA-
FCT0 ...9, A...F
MM / IN
KEY0 / KEY1
MUL [+/-] xx.xxxx
PRE [+/-] xxxx.xx
REF1 / REF2 / REFA
STO1 / STO0
TOL1 / TOL0
ECO1 / ECO0
LCAL dd.mm.yy
NCAL dd.mm.yy
TOL +/-xxxx.xx +/-zzzz.zz
MIN / MAX / DEL / NOR
CLE
UNI1 / UNI0
OUT1 / OUT0
PRE ON / PRE OFF
PRE
SET
SBY xx
NUM x...x (up to 20 chars)
Interrogation
?
CHA?
FCT?
Change measurement direction
Assign «favourite» function
Change measurement unit
Lock / unlock keypad
Modify multiplication factor
Modify preset value
Change the active reference
Activate/de-activate HOLD
Activate/de-activate tolerances
Activate/de-activate economic mode
Modify last calibration date
Modify next calibration date
Inputting tolerance limits
Selecting MIN, MAX, Delta, Normal mode
Re-initialisation of MIN, MAX or Delta mode
Activate/de-activate change of units
Activate/de-activate contin. data transmission
Activate/de-activate change of preset
Recall preset
Zero reset
xx number of minutes before stand-by entry
Modify the instrument number
Current value? (mode Tol, value followed by <=>)
Measurement direction?
«Favorite» function active?
15
E