GRAUPNER 3971 Notice D'utilisation page 6

Technical features/function
-Switched functions and jumper positions for the four outputs L1 to L4:
Jumper position (FUNC.)
None (all pins open)
Top (centre pin to top pin)
Bottom (centre pin to bottom
pin)
• Select the desired function for each output L1 to L4, referring to the table above, before
switching the SXM on.
• When the SXM is switched on, all switched functions are always disabled, i.e. OFF.
• The switching contact connects (ON) or disconnects (OFF) the terminals (L1 to L4) of the
selected function to (-).
• If the control for the channel to which the SXM is connected (RX) is moved as in the table
below, the switched functions for L1 to L4 are activated or disabled.
Channel movement
- (Negative) less than about 0,75 seconds
- (Negative) more than about 0,75 seconds
+ (Positive) less than about 0,75 seconds
+ (Positive) more than about 0,75 seconds
• To minimise the risk of the unit switching on or off accidentally, a further switching process
cannot take place until the control for that channel is moved back in the direction of neutral
by a significant amount.
• When the function is changed by the jumper, the module and the receiver must be pow-
ered off. Only then the change is stored in the module!
Receiver
connection
6
Function
On/Off (memory)
Memory switch On/Off
Flashing light On/Off (memory)
Switched function
L1
L2
L3
L4
Note
For L1 to L4
Only for L2 and L4
L1 and L2 at 1Hz
L3 and L4 at 2Hz