Cleaning Surfaces; Troubleshooting; Remedying Problems Yourself - SEVERIN KA4813 Mode D'emploi

10. Press the " " button to switch off the hotplate
11. Run the device through two rinsing cycles, ►"7.3 Running water
through the appliance" on page 31, to remove the remains of the
water/vinegar solution.

7.5 Cleaning surfaces

Clean the surfaces of the appliance with a soft, lint-free cloth.

8 Troubleshooting

GB

8.1 Remedying problems yourself

WARNING!
Risk of injury! The appliance does not contain any
parts that you can repair yourself.
– Never attempt to operate a defective appliance.
– Never attempt to repair the appliance by your-
self. If your appliance is defective, contact our
customer service department (see ►" Service
Centres" on page 192).
32
.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
Before contacting our customer service, check with the aid of the table below
whether you can remedy the problem yourself.
Problem Cause
The appliance The appliance is
will not switch not connected
on. to the power
supply.
Coffee does Coffee jug not
not flow out of placed correctly
the outlet (drip under outlet.
stop).
Coffee is too Grind set too
watery. coarse.
Too little ground
coffee.
All display The device must
indicators be descaled.
flash.
Error codes Problem with
E01 / E14 the grinder
Error codes PCB fault
E12 / E13
Remedy
Plug the power plug into a socket
outlet with earthing contact.
Check that the coffee jug is placed
correctly on the hotplate and that is
presses up the valve in the outlet.
Set the grind finer, ►"Adjusting the
grind" on page 27.
Refer to the measurement table,
►"5.2 With ground coffee" on page
28.
Carry out descaling ►7.4 Descale
device
Call customer service.
Call customer service.