HI-Q TOOLS 60150700030 Mode D'emploi page 4

HI-Q TOOL WORK STAND II
Ord. Nr. 60150700030
CONTENT
1 work stand
2 rubbered swing arms
2 castors incl. fi xing material
The HI-Q TOOLS work stand II simplifi es a lot of reparation and mounting work on your two-whee-
ler. Modern motorcycles often have a high empty weight of several hundred kilogramms. Therefore
please use the HI-Q TOOLS work stand II always with the greatest care in accordance to these
operating instructions and the manufacturer's specifi cations to avoid damage on your two-wheeler
and injuries on involved persons. The HI-Q TOOLS work stand II with the delivered swing arm sup-
ports is only appropriate for jacking up motorcycles with rear swing arm with straight box profi le.
Never use the HI-Q TOOLS work stand II for other purposes.
OPTIONALLY AVAILABLE
Racing adapter incl. silver castors
Ord. Nr.
60150200480
60150200530
60150200490
60150200540
60150201401
60150201391
to use on the swing arm, if thread is existing!
ASSEMBLY
The HI-Q TOOLS work stand II is ready as soon as the supports (pointing inwards) are put into the
open bars of the lift and fi xed with the screws (on each side) possible widths: with rubbered angle
22-31cm, with racing adapter 21-34 cm. The self-locking nuts of the safety srews are tightenend
gently without tightening the profi le of the stand. If the swingarm has a thread support, we recom-
mend to use the optionally available racing adapter with castors (view abbove).
If there is a swing arm with straight box profi le with thread supports, use the rubbered swing arm sup-
ports (included in the delivery). The HI-Q TOOLS work stand II is not appropriate for triangle swing
arms or hooked „banana swing arms" without thread supports or one arm swing arms.
USE
Thread
M6
M8
M10
M12
M6+M8
M10