HI-Q TOOLS 60150700030 Mode D'emploi page 5

EN
Before using the HI-Q TOOLS work stand II check if your motorcycle generally fulfi ls the conditions
to be lifted by the HI-Q TOOLS work stand II.
The max. load capacity is 150 kg – therefore the total weight of the two-wheeler incl accessories
may not exceed 300 kg. The rear swing arm has to be appropriate for the lift (no construction forms
as described above). If the rear swing arm shall be demounted, the axle has to be loosened before
jacking up the motorcycle. The same is valid for other tightened boltings on the two-wheeler. Never
jack up the motorcycle alone – let yourself help by a second strong person, keeping the motorcycle
on the handlebar in vertical position. Lifting the two-wheelers if it is standing inclined on the side
stand, can damage the HI-Q TOOLS work stand II and may cause that the vehicle slips off.
USE WITH RUBBERED SWING ARM SUPPORTS
DIRECTLY ON THE SWING ARM
Mount the rubbered swing arm supports and adjust the width of the HI-Q TOOLS work stand
II on your two-wheeler. Put the supports from the back on the swing arm bars of the motorcy-
cle and move the supports so they are completely under both bars. The swing arm bars have
to be put onto the swing arm supports in full width to make sure the motorcycle is carried sa-
fely. Generally the swing arm bars do not have to be positioned strongly angled on the vehicle.
Axle, pieces of the wheel adjustment, shock absorber mountings and other protruding
construction pieces do not have to be put on the swing arm supports to avoid damage on
the HI-Q TOOLS work stand II or your vehicle. Put the HI-Q TOOLS work stand II with the
supports on the rear third of the swing arm bars, so they rest safely on full width. Before lifting the
motorcycle make sure again, that the HI-Q TOOLS work stand II is safely assembled and the
helping person keeps the vehicle safely in position. Then press the motorcycle lift on the
connection tube strongly but slowly under the vehicle until it lies on the lift.
Thus we can guarantee the correct mounting and use of the product.