Ibiza sound WAVE10 Manuel D'utilisation page 5

searching will stop and the found stations will be saved automatically. You can access the stored stations via the
number buttons on the remote control.
AUX mode
Connect an audio lead from the Line output of your audio device to the AUX input on the unit. When a device
is plugged into the AUX socket, it will disconnect all other audio devices. In AUX mode, all functions can be
controlled by the external device.
TWS function
1. Make sure both speakers are OFF.
2. Go to your phone's Bluetooth interface and make sure that it is not connected to either of the speakers. If
your phone is connected, choose to forget or remove the speakers from the list of available devices.
3. Turn both speakers ON, press the MODE button on both speakers. The word « BLUE » should appear on both
LCD screens and flash intermittently.
4. Press the « NEXT » button on either one of the speakers for 5 seconds. Both units will enter pairing mode.
5. One of the units will show the word « BLUE » on the LCD display. This is the master unit and will act as the
left channel, while the other one will be the slave unit and will act as the right channel.
6. Go to your phone's Bluetooth interface and select « WAVE10 » from the list of available devices. If pairing is
successful, the word BLUE on the master unit will stop flashing.
7. To disconnect the speakers, select any other mode on either one of the speakers.
Trouble shooting
If a problem occurs, follow the steps in the table below. If problem still can't be solved, please contact your
retailer.
Problem Possible cause
1. The power cord is not connected
2. Faulty mains outlet
No sound when
power is turned on
3. No input source
4. Volume set to minimum
1. Master volume is set too high
Distorted sound
2. Damaged speaker
1. Microphone plug is not firmly inserted
No sound from
2. The microphone is not switched on
Karaoke
3. Mic volume set to the minimum
1. Un supported file format
No sound from MP3
2. Illegal copy
source
3. USB/TF source not properly inserted
Specifications
Power supply .......................................................................................................... 100-240V~50/60Hz
RMS/Max. power ................................................................................................................... 400/800W
Impedance ................................................................................................................................ 4 Ohms
Freq. response................................................................................................................... 55Hz -20kHz
Sensitivity .......................................................................................................................85dB (+/-2dB)
BT band......................................................................................................................... 2402-2480MHz
Max. RF emission value .......................................................................................................... 2.18dBm
FM band ........................................................................................................................... 87.5-108MHz
Dimensions ........................................................................................................... 360 x 310 x 870mm
Weight ........................................................................................................................................ 15.9kg
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent
possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take this product for environmental safe recycling.
MANUAL - WAVE10
Solution
1. Connect the power cord
2. Use an outlet that receives power
3. Connect an input source
4. Set the volume to an appropriate level
1. Reduce the volume
2. Check if the speaker is damaged
1. Insert the mic firmly into the socket
2. Switch the microphone on
3. Increase the microphone volume
1. Change into MP3 format
3. Insert the USB/TF source properly
5