Scanning for a channel
If an active channel is detected, the channel scan stops.
Press the P button to enable radio communication on this channel. The
S
walkie−talkie is set to the channel and channel scanning is ended.
If you do not press the P button, channel scanning is resumed five
S
seconds after no further signal has been transmitted on this channel.
Start / End channel scanning
5 x M, Y / X
The scanning routine stops at every channel on which a signal is received regardless
of the CTCSS/DCS code transmitted with the signal.
6 x M, Y / X
The scanning process stops when a signal with a CTCSS code is transmitted on the
set channel.
7 x M, Y / X
The scanning process stops when a signal with a DCS code is transmitted on the set
channel.
P
Transmitting the ringing tone
The ringing tones indicate to other subscribers that you want to talk to them. A condi-
tion for this is that the other subscribers are using the same channel and CTCSS/
DCS code.
Selecting/Deactivating ringing tones
There are 5 ringing tones available for selection.
8 x M
Y / X, P
1
DCS: Digital Coded Squelch = Selective call
2
CTCSS: Continous Tone Coded Squelch System = Selective call
Operating the Walkie−Talkies
Start channel scanning
Start channel scanning with CTCSS
Start channel scanning with DCS
End channel scanning
Transmit the ringing tone
Open the menu
Select a ringing tone and confirm it
2
1
57