Operating; Cleaning And Maintenance - TECMIX TMX EB 2000 Notice D'utilisation D'origine

Stop the engine
Press the stop switch (Fig. 4, A) in the 'Stop' position.
When restarting, first press the stop switch (Fig. 4, A) back to the 'Start' position.
Before starting the motor, check the following:

Fuel level - the fuel tank should be at least half full

Condition of the fuel lines

Outer screw couplings for tight fit

The earth auger has to be able to run freely

Operating


Set the auger down and actuate the throttle control lever (Fig. 4, B).

Adjust the power according to the ground conditions in order to be able to proceed ideally.

If the ground condition is ideal, permitting a steady work speed, using the adjusting screw (Fig. 4, C), you can lock the
throttle control lever (Fig. 4, B) (in the centre position) in order to make your work easier.
When leaving the auger, the motor must always be turned off.

Cleaning and maintenance

Cleaning

We recommend that you clean the device immediately each time you have finished using it.

Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these
could attack the plastic parts of the equipment. Ensure that no water can seep into the device.
Maintenance
For all work on the machine, the spark plug cap and the spark plug have to be removed (high voltage).
Please adhere to the maintenance schedule.
Daily before beginning work
Check fuel tank and fuel lines for tightness.
Check mounting parts, exhaust cover, air filter cover, oil, position of the auger and functioning of the operating elements.
After 20 operating hours
Clean air filter and check spark plug
After 100 operating hours
Clean fuel tank and replace spark plug
After 300 operating hours
Replace air filter
Important notice in the event of repairs:
When sending earth augers to be repaired, please note that, for safety reasons, they must be delivered to the service station free
from oil and petrol.
Warning! No smoking and no open fire.
Risk of explosion.
Air filter, Fig. 6
Regular cleaning of the air filter prevents carburettor malfunctions.
Cleaning the air filter and replacing the air filter insert:

Loosen the screw (A) on the air filter casing , remove the air filter cover (Fig. 6, C) and check it.

Replace the damaged element.

Clean dirt from the inside of the filter casing with a clean, damp cloth.

Carefully remove the foam filter insert (B) and check it for damage, replace if required.

Clean the foam filter insert (B) in warm water and with a mild soap solution. Thoroughly rinse it with clear water and
leave it to dry.
30