Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 5
Caution: It is wise to wear
leather gloves while attaching
the Springs. Be careful where you
place your hands as the Springs
and frame joints can pinch.
Attach the Springs (7) as follows:
Hook one end of a Spring ( 7 ) into a
V-ring sewn on the Jump mat. Hook
a Spring tool (10) shown as the inset
drawing in next to the free end of
the Spring(7 ). Pull it by the spring
tool(12) unti l it reaches the frame.
Push the end of the Spring into a hole
in the frame. Unhook the Spring tool.
First place 8 V-rings with white color
of mat seperately on the both side
of the T-joint (Socket) and attach
2 springs at #1 to both mat and
frame. Then attach 2 springs at #2,
2 springs at #3 and 2 springs at #4
in the same way until 8 springs have
been attached. Make sure to count
the holes in the frame and V-rings of
the mat in the apropriate position.
Contine to attach 2 springs at #5,
#6, #7, #8 until the second 8 springs
have been attached. Be sure to match
the correct mat ring to the correct
frame hole. After these springs have
been attached continue to attach all
remaining springs to the mat and
frame in any order.
Note:The spring has a large hook
which attaches to the frame and a
small hook which attaches to the
mat ring.
Safety Notice:
as you attach Springs, care-
fully count the V-rings and frame
holes. If a V-ring or a hole is
skipped, reattach the spring in
the proper position.
WARNING!! : Please be careful where your hands and other parts of the
body are placed as the connector points and spring attachments can cre-
ate hand or body traps.
16
5
#8
#4
#7
#1
#2
#3
8ft
1
14
28
10ft
1
16
32
12ft
1
18
36
14ft
1
22
44
InTerra
Trampolines
6
V-ring
7
12
Frame
#1
#5
#6
#3
#4
#5
#6
#7
42
7
21
35
48
8
24
40
54
9
27
45
66
11
33
55
#2
#8
49
56
63
77
Publicité
Table des Matières
