The Option Menu - Sony VPH-G70Q Mode D'emploi

INPUT MEMORY NO.
The upper number is the memory number of the data
automatically loaded when the current signal is input.
The lower number is the new memory number in
which the adjustment data of the current input signal is
stored. The existent memory number is displayed in
green, and a new memory number in yellow.
By default ten basic data are preset in the following
memory numbers.
Preset signal
Memory
frequencies
number
fH
00 15.7 kHz
01 24.8 kHz
02 31.5 kHz
48.3 kHz
03
64.0 kHz
04
75.0 kHz
05
06 93.7 kHz
07
106.3 kHz
08
31.5 kHz
09 33.8 kHz
FREQUENCY SENSITIVITY
Selects the sensitivity to the frequency deviation of the
input signal, with which the INPUT MEMORY data is
switched automatically. This item can be selected only
for RGB input signals.
Press the b key or the ENTER key on the INPUT
INFO menu, and the INPUT MEM. OPTION menu
appears. Press the b key or the ENTER key again to
show the frequency sensitivity options.
I N P U T - A
I N P U T M E M . O P T I O N
F R E Q U E N C Y H I G H
S E N S I T I V I T L O W
SEL: SET: ENTER EXIT: MENU
HIGH: This position is selected at the factory.
LOW: Set to this position if the input signal is
unstable or flickers. This phenomenon may
appear during variable speed playback by the
VCR, etc.
Types of the
input signal
fV
60 Hz Video (NTSC )
3.58
56 Hz RGB
60 Hz RGB
60 Hz RGB
60 Hz RGB
60 Hz RGB
75 Hz RGB
85 Hz RGB
60 Hz IDTV (NTSC )
3.58
HDTV (Y/P /P )
60 Hz
B R

The OPTION Menu

The OPTION menu is used when installing the EXB-
DS10 Extension Board to the projector.
I N P U T - A
I N T I D T V
OPTION
SEL: SET:
ENTER
INT. (internal) IDTV
Set to ON to project the video, S video, component or
RGB (15 kHz) signal at double density.
I N T I D T V
I N T . I D T V : O N
V A P E R T U R O F F
SEL: SET: EXIT: MENU
ENTER
V. (vertical) APERTURE
Corrects the sharpness in the vertical direction. You
can set the sharpness to the LOW, MID (middle) or
HIGH level.
I N T I D T V
I N T . I D T V : O F F
V A P E R T U R E : L O W
M I D
H I G H
SEL: SET:
ENTER EXIT: MENU
EXIT: MENU
33
(EN)