English
APPLICATIONS
For charging the metabo HPT batteries types BSL14, BSL18, BSL25 and BSL36 series and
back pack power supply type BL36200.
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
: Do not charge at voltage higher than indicated on the nameplate.
1. Connect the battery charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle, the charge indicator lamp will
blink in red. (At 1-second intervals).
2. lnsert the battery or adaptor of back pack power supply into the charger.
<Charging the Battery>
Firmly insert the battery into the charger as shown in Fig. 2.
<Charging the Back Pack Power Supply>
Place the back pack power supply in a horizontal position and turn it on by the switch on
the side. Firmly insert the adaptor into the charger until the line is visible, as shown in
Fig. 2.
NOTE:
If the charge indicator lamp of the charger lights in red (high temperature standby status)
when the adaptor is inserted into the charger, check that the battery status lamp on the
back pack power supply control panel is lit in red.
If the battery status lamp is OFF, the back pack power supply switch may be turned OFF.
If the back pack power supply switch is turned OFF, disconnect the adaptor and turn on the
switch before reinserting the adaptor.
8
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
WARNING
: Do not use the electrical cord if damaged. Have
it repaired immediately.