Metabo HPT UC 36YSL Instructions De Sécurité Et Mode D'emploi page 11

State of lamp
NOTE
A short time after charging is complete, the battery capacity lamp turns off .
<Charging the Back Pack Power Supply>
NOTE
○ When the back pack power supply is being charged, the charger's battery capacity lamp
does not light up.
Use the remaining capacity indicator lamp on the back pack power supply's switch panel
as an estimate of how much charge time remains.
○ If the back pack power supply is being charged and the charge indicator lamp blinks red
(high temperature standby status), allow the back pack power supply to cool for about 5
minutes or turn the switch on the side of it ON.
(3) Regarding the temperature of the rechargeable battery and back pack power supply.
The temperature for rechargeable batteries and back pack power supply are as shown in
the Table 4, and batteries and back pack power supply that have become hot should be
cooled for a while before being recharged.
Rechargeable batteries and back pack
power supply
BSL1415S, BSL1415, BSL1415X,
BSL1420, BSL1425,
BSL1430, BSL1440, BSL1450, BSL1460
BSL1815S, BSL1815, BSL1815X,
BSL1820, BSL1825,
BSL1830, BSL1840, BSL1850, BSL1860
BSL2530
BSL3620, BSL3625,
BSL3626, BSL3626X, BSL3660
BL36200
Blinks Battery capacity at less than 25%
Blinks Battery capacity at less than 50%
Blinks Battery capacity at less than 75%
Blinks Battery capacity at more than 75%
Lights Charging complete
Table 3
Battery capacity
Table 4
Temperature which the battery and back
pack power supply can be recharged
14°F — 122°F
(-10°C — 50°C)
English
11