Applications; Charging Method - Metabo HPT UC 10SL2 Instructions De Sécurité Et Mode D'emploi

English
SPECIFICATIONS
Input power source
Charging time
Charger
Weight

APPLICATIONS

For charging the metabo HPT batteries type BCL10 series.

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
8
Single phase: AC120V 60Hz
BCL1015S .......................... Approx. 25 minutes
BCL1015 ............................ Approx. 30 minutes
BCL1030 ............................ Approx. 60 minutes
Charging voltage .............................. DC 10.8 V
Charging current .............................. DC 3.0 A
0.8 lbs (0.35 kg)
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
WARNING:
Do not use the electrical cord if damaged. Have it repaired immediately.