Extending The Loudspeaker Array; Connecting Power To The System - Bose L1 Compact Notice D'utilisation

English TAB

Extending the Loudspeaker Array

Once you have set the system in place:
1. Slide the Loudspeaker Array up and out of the Power Stand and temporarily lay
it aside.
Note: The two L1
be used on the top or bottom, but if one extension is used, both must be used.
2. Align the plug on the bottom of the Extension with the socket on the Power
Stand, then slide the extension into the power stand.
Be sure to fully insert the extension into the Power Stand socket to assure
stability and a good connection.
1
3. Align the remaining Extension and push it firmly in place.
4. Align the Loudspeaker Array and push it firmly in place.
3

Connecting power to the system

1. Make sure the power switch is off (down position).
2. Plug one end of the power cord into the connector on the power stand.
3. Plug the other end into a live electrical receptacle.
1
4. Before turning the system on, connect your sound sources. See "Operating
Information" on page 6, and "Plugging in your sources" on page 7.
TAB TAB 4, 11
® Compact Extensions are identical to each other. Either one can
3
TAB 5, 12 TAB 2, 9, 16
S
2
4
2
TAB 1, 8, 15
S
YSTEM ETUP
5