Install The Batteries; Getting Started - Orbit WaterMaster 57674 Manuel D'installation

WTM220330 57962-24 rG.qx
2
s e c t i o n
Programming the Timer can be accomplished in just a few basic steps. Before
you begin programming, it is important to install the battery, set the time of
day and date, and establish a watering plan.

Install the Batteries

The Timer requires two AA batteries to maintain the time and date in case of
AC power loss. In a typical installation, fully charged batteries should provide
sufficient power for approximately three years of operation.
Remove the terminal cover.
Insert two AA batteries into the battery compartment.
Return the terminal cover to its closed position.
Weak or missing batteries can cause the time and date to be erased after a
power failure. If this happens, you will need to install fully charged batteries
and re-enter the time and date. All other program settings will be maintained
in non-volatile memory. The display will show "LO BAT" when it is time to
replace the battery.
Set the Time of Day and Date
If this is the first time the Timer has been programmed, you should press the
small recessed button labeled
RESET
installed fail-safe program [See Figure 2].
MANUAL
ENTER
FIGURE 2: Programming Keys
Turn the rotary dial to the
TIME
12:00 AM will appear in the display with three arrows pointing to the year,
month, and day.
Use the + and - keys to set the correct time of day. When the correct time
of day is reached, press the
ENTER
decrease more rapidly, hold down either the + or – keys until the display
goes into rapid advance mode.
A blinking cursor will appear below the arrow for the year, month, and
date when programming [See Figure 4].
Use the + and – keys to set the correct year, then press
Use the + and – keys to set the correct month, then press
Use the + and – keys to set the correct date, then press
12/14/01 1:16 PM

Getting Started

. Pressing does not affect the factory
RESET
CLEAR
RAIN DELAY
NEXT
RESET
/
position [See Figure 3].
DATE
key to lock in the time. To increase or
.
ENTER
.
ENTER
.
ENTER
Page 2
CYCLE
START TIMES
FIGURE 3: LCD Display with Surrounding Information
Caution: If a watering schedule is not entered into the Timer, the factory installed
fail-safe program will turn on each station every day for 10 minutes.
To avoid accidental valve activation, either turn the rotary dial to
watering schedule.
Establish a Watering Schedule
To help you visualize how best to program the Timer, it might be helpful to
make a watering plan on paper. This will help you establish which days and
times you want to water.
2
PROGRAM
M T W T F S S 2nd
1
12:00
2
AM
INTERVAL
3
ODD
4
EVEN
1 2 3 4 5 6 7 8 9 10 11 12
ZONE
Cursor
5:00
AM
FIGURE 4
OFF
s e
or enter a