Cleaning And Maintenance; Replacing The Fuse; Technical Specifications - EuroLite AT-DIMM 3100 DMX Mode D'emploi

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you need any spare parts, please use genuine parts.

TECHNICAL SPECIFICATIONS

Power supply:
Max. power output:
Output voltage:
Number of control-channels:
Max. output/channel:
Integrated programs:
Fuse:
DMX output:
DMX input:
Dimensions (WxDxH):
Weight:
Please note: Every information is subject to change without prior notice. 31.10.2006 ©
Press FUNC once more, until the display indicates FD00. Use UP and
DOWN to set a Fade (FD) speed between 0 and 10 seconds.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
230 V AC, 50 Hz
320 W
24 V DC
3
100 W
4
F 3.15 A, 230 V
3-pin female XLR socket
3-pin male XLR socket
360 x 165 x 65 mm
2.5 kg
19/36 70064175_V_1_1.DOC