ALPHA-TOOLS AHS 66-1 Mode D'emploi page 9

Anleitung AHS 66-1 AlphaTools
1
Adjustment of the shoe (cutting angle)
1. Release the lock screws 1
2. Adjust the shoe to the desired angle between 0 and 45°.
3. Tighten the lock screws 1.
Switching on and off
To switch on: Press the interlock button 3 and the switch 4
simultaneously.
To switch off: Release the interlock button and the switch.
3
4
01.07.2003 10:13 Uhr
Switching on
Important!
Pull out the plug before
Before pressing the On/Off
making any changes to the
switch, check that the saw blade
circular saw!
is properly fitted, that the moving
parts run smoothly and that the
clamping screws are tight.
1
1
4
2
Changing the saw blade
1. Open the hinged guard hood 1 and hold.
2. Use the face spanner 2 to stop the saw blade from moving.
3. Undo the screw with the wrench.
4. Remove the flange 4 and the saw blade by dropping down
and out.
5. Clean the flange and insert a new blade. Note the direction
of rotation (see arrow on the guard hood).
6. Tighten the screw and check for concentricity.
Seite 9
GB
9