Before Installation - Etherma One Série Mode D'emploi

Installation or disassembly
Detailed information on all possible ways
of the device installation or disassembly, is
available from the manufacturer or import-
er of the item (see footer at the bottom of

Before installation

1. Read chapter: Guide to safe installation.
2. If you are installing the 'ONE electric ra-
diator' go straight to point 10.
3. The device is intended for operation in
a vertical position with heating element
turned upwards.
4. Always use the correct radiator approved
heating mediums only (water, water with
addition of radiator approved anti-freeze
agent only, selected types of oil).
5. Do not turn the device on if not immersed
in water or other liquid as it could cause
damage to thermal fuse and will not be
liable for claim under warranty.
6. Ensure all necessary safety measures in
order to avoid excessive pressure inside
the radiator (allow the right space for air-
bag or leave at least one of the central
heating valves open).
the manual). Below are the most important
requirements and guidelines which should
be strictly followed in order to ensure a long
term, unfailing operation of device.
7. Do not fill the radiator with liquids of
temperature higher than 65° C .
8. Do not install the device in central heat-
ing systems where temperature of liquid
inside the system may exceed 82° C .
9. Make sure that connection 'radiator —
heater' is tight prior to filling the radia-
tor with heating liquid (does not concern
devices preinstalled at the manufactur-
er's or heater versions built-in inside the
radiator).
10. When connecting the device to installa-
tion, follow below instructions:
a. Brown wire — connection to live cir-
cuit (L)
b. Blue wire — connection to neutral cir-
cuit (N)
c. Yellow & green wire — connection to
earth (PE).
11. For detailed installation hints — see the
last pages of this manual.
23