Cleaning And Maintenance - Bosch MUZ4MM3 Mode D'emploi

7. Place the multimixer on the base unit.
Observe the marking Æ when doing so.
8. Rotate as far as possible in an anticlock­
wise direction.
Note: The appliance will not start if the
multimixer is not screwed on tight.
9. Plug the mains plug into the mains. Turn
the rotary switch to the recommended
speed.
10. Place the food to be processed in the
feed chute.
11. Push down lightly with the pusher.
Caution!
– Observe the maximum filling level.
The food should not come into contact
with the disc holder.
– If the food to be processed sticks in the
multimixer, switch the food processor
off, disconnect the mains plug, wait until
the drive comes to a standstill, remove
the multimixer from the drive, remove
the lid from the multimixer and empty
the feed chute.
12. Move the rotary switch to y and wait
for the appliance to come to a standstill.
Disconnect the mains plug.
13. Rotate the multimixer in a clockwise
direction and remove.
14. Rotate the lid in a clockwise direction
and remove.
15. Take the disc holder with the cutting disc
out of the container.
16. Empty the multimixer.
■ Clean all parts directly after use.
X "Cleaning and maintenance" see
page 11
Tip: To ensure evenly cut ingredients,
process slender ingredients in bunches.
Cleaning and maintenance

Cleaning and maintenance

The attachments and accessories used
must be thoroughly cleaned after each use.
W Risk of injury
– Do not touch the edges of the multifunc­
tion blade with bare hands. To clean
the multifunction blade, hold it by the
plastic only. When not in use, always
store the multifunction blade in the blade
guards. Clean with a brush.
– Do not grasp the sharp blades or edges
of the cutting discs. Grasp the discs by
the plastic part in the centre only!
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Do not wedge plastic parts in the
dishwasher as they could become
permanently deformed.
In Fig. D you will find a summary of how to
clean the individual parts.
Please note:
– When processing food such as
carrots, the plastic parts may become
discoloured, but this can be removed
with a few drops of cooking oil.
Predetermined breaking
point
The built­in predetermined breaking point
protects the drive of the appliance. If
an overload occurs, the disc holder on
the drive shaft breaks and can easily be
replaced. A replacement disc holder is
available from a dealer or customer service
(order no. 00088256).
en
11