DeWalt DC413 Guide D'utilisation page 15

CAUTION: If the guard cannot be tightened by the adjusting clamp,
do not use the tool. To reduce the risk of personal injury, take the tool
and guard to a service center to repair or replace the guard.
CAUTION: To reduce the risk of damage to the tool, do not tighten
the adjusting screw with the clamp lever in the open position.
Undetectable damage to the guard or the mounting hub may result.
NOTE: Edge grinding and cutting can be performed with Type 27
wheels designed and specified for this purpose; 1/4" (6.35 mm) thick
wheels are designed for surface grinding while 1/8" (3.17 mm) wheels
are designed for edge grinding. Cutting can also be performed by
using a Type 1 wheel and a Type 1 guard.
OPERATION
Switch
LOCK-OFF BUTTON AND
TRIGGER SWITCH
Your cut-off tool is equipped
with a lock-off button (B).
B
To lock the trigger switch,
press the lock-off button as
shown. When the lock-off
button is depressed to the
lock icon, the unit is locked.
Always lock the trigger
switch when carrying or
storing the tool to eliminate
unintentional starting.
To unlock the trigger switch, press the lock-off button. When the
lock-off button is depressed to the unlock icon, the unit is unlocked.
The lock-off button is colored red to indicate when the switch is in its
unlocked position.
UNLOCKED
LOCKED
A
13
Pull the trigger switch (A) to turn the tool ON. Releasing the trigger
switch turns the tool OFF.
NOTE: This tool has no provision to lock the switch in the ON position,
and should never be locked ON by any other means.
CAUTION: Hold the side handle and body of the tool firmly to
maintain control of the tool at start up and during use and until the
wheel or accessory stops rotating. Make sure the wheel has come
to a complete stop be fore laying the tool down.
CAUTION: Allow the tool to reach full speed before touching
tool to the work surface. Lift the tool from the work surface before
turning the tool off.
SPINDLE LOCK
The spindle lock pin is provided to prevent the spindle from rotating
when installing or removing wheels. Operate the spindle lock pin
only when the tool is turned off, the battery is removed, and the
wheel has come to a complete stop.
CAUTION: To reduce the risk of damage to the tool, do not engage
the spindle lock while the tool is operating. Damage to the tool will
result and attached accessory may spin off possibly resulting in
injury.
To engage the lock, depress the spindle lock button and rotate the
spindle until you are unable to rotate the spindle further.
Mounting and Using Depressed Center
Grinding Wheels and Sanding Flap Discs
MOUNTING AND REMOVING HUBBED WHEELS
WARNING: To reduce the risk of serious personal injury, turn
tool off and and remove battery pack before making any
adjustments or removing/installing attachments or accessories.
Hubbed wheels install directly on the 5/8"-11 threaded spindle.
1. Thread the wheel on the spindle by hand.