Cleaning And Disposal - DeWalt DC413 Guide D'utilisation

CLEANING AND DISPOSAL

1. All surfaces in the work area should be vacuumed and
thoroughly cleaned daily for the duration of the sanding project.
Vacuum filter bags should be changed frequently.
2. Plastic drop cloths should be gathered up and disposed of
along with any dust chips or other removal debris. They should
be placed in sealed refuse receptacles and disposed of through
regular trash pick-up procedures.
During clean up, children and pregnant women should be kept
away from the immediate work area.
3. All toys, washable furniture and utensils used by children should
be washed thoroughly before being used again.
Mounting and Using Wire Brushes
and Wire Wheels
Wire cup brushes or wire wheels screw directly on the grinder
spindle without the use of flanges. Use only wire brushes or wheels
provided with a 5/8"-11 threaded hub. A Type 27 guard is required
when using wire brushes and wheels.
CAUTION: To reduce the risk of personal injury, wear work
gloves when handling wire brushes and wheels. They can
become sharp.
CAUTION: To reduce the risk of damage to the tool, wheel
or brush must not touch guard when mounted or while in use.
Undetectable damage could occur to the accessory, causing wires
to fragment from accessory wheel or cup.
MOUNTING WIRE CUP BRUSHES AND WIRE WHEELS
WARNING: To reduce the risk of serious personal injury,
turn tool off and and remove battery pack before making any
adjustments or removing/installing attachments or accessories.
1. Thread the wheel on the spindle by hand.
2. Depress spindle lock button and use a wrench on the hub of the
wire wheel or brush to tighten the wheel.
3. To remove the wheel, reverse the above procedure.
CAUTION: To reduce the risk of damage to the tool, properly seat
the wheel hub before turning the tool on.
USING WIRE CUP BRUSHES AND WIRE WHEELS
Wire wheels and brushes can be used for removing rust, scale and
paint, and for smoothing irregular surfaces.
NOTE: The same precautions should be taken when wire brushng
paint as when sanding paint (see page 16).
1. Allow the tool to reach full speed before touching the tool to the
work surface.
2. Apply minimum pressure to work surface, allowing the tool to
operate at high speed. Material removal rate is greatest when
the tool operates at high speed.
3. Maintain a 5˚ to 10˚ angle between the tool
and work surface for wire cup brushes.
4. Maintain contact between the edge of
the wheel and the work surface with wire
wheels.
5. Continuously move the tool in a forward
and back motion to avoid creating gouges in the work surface.
Allowing the tool to rest on the work surface without moving, or
moving the tool in a circular motion causes burning and swirling
marks on the work surface.
6. Remove the tool from the work surface before turning the tool off.
Allow the tool to stop rotating before setting it down.
CAUTION: Use extra care when working over an edge, as a
sudden sharp movement of grinder may be experienced.
17
5˚-10˚