Ordering Replacement Parts - EINHELL BM 200 Mode D'emploi

Anleitung BM 200 SPK 1 14.03.2005
GB
9.2. Making angular cuts (Fig. 19)
Set the saw table to the desired angle (see 8.3).
Carry out the cut as described in 9.1.
9.3. Freehanded cuts (Figure 21)
One of the most outstanding features of a bandsaw
is the ease with which it allows you to make curved
cuts and radii.
Lower the blade guide (11) to the workpiece (see
7.5).
Switch on the saw.
Hold the workpiece securely on the table (15)
and guide slowly through the blade (26).
Freehanded cuts should be made at low feed
speed so that you can guide the blade (26) along
the required line.
It often pays to first cut off surplus curves and
corners up to about 6 mm from the cutting line.
In the case of curves which are too tight for the
blade to cut correctly, it can help to make a
series of close-lying cuts at right angles to the
curved line. When you saw the radius the
material will simply drop off.
10. Maintenance
Caution! Pull out the power plug first.
Remove dust and dirt regularly from the
bandsaw. Cleaning is best carried out with a fine
brush or a cloth.
Do not use caustic cleaning agents for cleaning
plastic.

11. Ordering replacement parts

Please provide the following information on all orders
for replacement parts:
Type of machine
Article number of the machine
ID number of the machine
Replacement part number of the part you require
(Please refer to the list of replacement parts).
22
16:37 Uhr Seite 22