Rowenta ES-055 Notice D'emploi page 12

allegro corrections*
Important: do not pack down the ground coffee.
6. Fit the filter-holder into the appliance turning it from left to right and locking it firmly into place (fig. 6).
7. Place a cup or low recipient (max. 20 ml) under the filter-holder (figure 7)
8. Turn the selector knob to "coffee" (fig. 8).
9. The ON/OFF pilot light will light up (fig. 9).
After 1 to 2 minutes, the coffee starts dripping.
Wait until the coffee has stopped dripping before removing the container/cup and then turn the selector
knob to the stop position. (fig. 1).
Be careful! We advise you not to switch off the appliance before the "coffee" cycle is completely
finished. At the end of the cycle, steam will dry out the coffee grounds thus producing a disc that is
dry and easy to remove .
10. Eliminate any remaining pressure in the appliance. To do this, unplug the appliance and turn the
knob to steam until all the pressure is completely released. Turn the knob back to stop (fig. 1).
Only once you have done this can the filter-holder be removed.
To throw away the coffee grounds, keep the filter in place by pressing down with your finger on the special
tipping lock, turn over the filter-holder and shake it to make the coffee grounds fall out.
6. PRODUCING STEAM FOR REHEATING
Steam is used to froth up milk and also to heat up water (tea, hot drinks).
1. Check that the appliance is unplugged and that there is no contained pressure.
2. Measure out a small amount of water and put it into the tank. For example: 50 ml of water
to heat up 100 ml of water.
Important: for maximum efficiency, avoid putting more than 100 ml of water into the tank.
3. Completely screw down the lid (fig. 4).
4. Plug in the appliance.
5. Immerse the steam nozzle in the liquid to be heated up
6. Turn the knob to
7. The ON/OFF pilot light will light up (fig. 9).
8. Steam is produced after 2 to 3 minutes preheating.
9. Once the liquid is hot, turn back to stop and unplug.
10. Before turning the knob again, turn the knob to the
to put a recipient underneath the steam nozzle.
Be careful to avoid the risk of burns.
Important: Immediately after use, wash the steam nozzle with a moist sponge.
If you want to make cappuccinos, add 50 ml to the volumes indicated above. We recommend frothing up the
milk before making the coffee. After having put the coffee into the filter-holder:
- Fill up a small recipient with milk (use full fat milk if possible for a denser froth). For instance: 2/3 frothy
milk to 1/3 espresso coffee.
- Turn the knob to the
When the steam starts coming out, immediately place the recipient underneath it and make circular move-
ments going up
and down to froth up the milk (fig 11). Put a cup underneath the filter-holder
- Turn the knob to the "coffee" position. Once the coffee has finished dripping, delicately pour on the frothy
milk to finish the cappuccino .
Let the pressure go down before opening the lid of the water tank.
18/09/02 16:34 Page 12
(fig. 10).
Making cappuccinos
position
position (fig. 10) to remove any steam, take care
12