Intended Use; Technical Data - TESTO 104 Mode D'emploi

10

10 4. Intended Use

4. Intended Use
The testo 104 is a robust food thermometer.
The product is designed for the following tasks/areas:
· Food sector: production, food service, spot check
measurement
· Measuring liquids, pastes and semi-solid materials
The product may not be used in the following areas:
· Potentially explosive areas
· For diagnostic measurements in the medical sector

5. Technical Data

Feature
Sensor type
Measurement range
Parameter
Resolution
Accuracy
Response time t99
Measuring rate
Operating temperature
Transport / storage temperature -30...+70°C
Power supply
Battery life
Housing
Protection class
Dimensions
Weight
Display
Standards
EC Directive
E
Warranty
The following product components are designed for continuous
contact with foodstuffs in accordance with Regulation (EC)
1935/2004:
From the tip of the immersion/penetration probe up to 2 cm before
the probe handle or the plastic housing. If provided, the information
about penetration depths under point 7.2 in the instruction manual or
the mark(s) on the immersion/penetration probes should be noted.
Values
NTC
-50...+250°C
Temperature in °C/°F/°R
0.1°C/°F/°R
±1.0 °C (-50.0...-30.1°C)
±0.5 °C (-30.0...+99.9°C)
±1 % of the measurement range (+100.0...+250.0°C)
10 s (measured in moving liquid)
2 measurements per second
-20...+60°C
2 x AAA batteries
100 h (typically at 25°C without display illumination)
ABS/TPE/PC and die-cast zinc/stainless steel
IP65
265 x 48 x 19 mm (immersion/penetration probe open)
165 g (incl. batteries)
LCD, single line, with status line (Hold/Auto Hold) illuminated
EN 13485
Certificates: see www.testo-international.com,
Service&Support | Download Center (registration required)
2004/108/EEC
2 years, warranty conditions: see www.testo.com/warranty
Information on standards
This product complies with the EN 13485 standard
Suitability: S, T (storage, transport)
Environment: E (transportable thermometer)
Accuracy class: 0.5
Measurement range: -50...+250 °C
According to EN 13485, the measuring instrument
should be checked and calibrated regularly under the
terms of EN 13486 (recommended frequency: yearly).
Contact us for more information.