Tubing Removal; Operation - Masterflex L/S 07534-04 Notice D'utilisation

Figure 6. Insert one end of the tubing over rollers.
Figure 7. Place tubing stop collar into slot to secure.
Figure 8. Secure tubing stop collar in corresponding slot.

4.3 TUBING REMOVAL

Follow this procedure to unload the tubing:
1. Turn the drive OFF.
2. Unlatch and open occlusion bed.
3. Pull tubing down from slot to release tubing stop collar
(Figure 9).
4. Release tubing stop collar from corresponding slot from
other side.
Repeat for additional channels.
Figure 9. Pull tubing down from slot to release tubing stop collar.
Bi-directional Pumping
Fluids can be pumped into and back out of containers by
reversing the drive.
Partial Bank Pumping
The pump can be operated with either a partial or full bank of
tubing sets.

5. OPERATION

This section describes the procedures for obtaining the
desired performance.
5