Pipe Cutter, Replacing Of Pipe Cutter Wheel - GF JRG Sanipex MT Notice D'utilisation Et D'entretien

5.3 Pipe cutter, replacing of pipe cutter wheel

Open the pipe cutter by operating the
lever. Push lock bolt (e.g. nail of
through the drilled hole. Thus the pipe
cutter remains secured open.
Danger:
Resile of pipe cutter wheel
Fingers can be hurt!
The pipe cutter wheel have to be changed only with locked lever
Remark:
Cutting wheel-axis
Since January 2002 only hubbed axis are used. These axis replaces the cylindrical
bolt with socket. A hubbed axis have to be used, as far as not yet available, changing
the cutter wheel.
The hubbed axis has the art. no. 16 003 15.
cylindrical bolt + separate socket
Detach the screw with a screwdriver.
3 mm) Replace the pipe cutter wheel.
Tighten the screw and remove the lock
bolt.
replace to
hubbed axis
81