Removing The Bending Tool; De-Commissioning The Hydraulic Device; Maintenance; Introduction - GF JRG Sanipex MT Notice D'utilisation Et D'entretien

• Remove the closure cap of the device socket (20) on the hydraulic device
• Connect the control cable (31) to the device socket (20) on the hydraulic device
• Switch on the hydraulic device
• The device is ready for operation for bending pipes, when the LEDs for the mains
voltage and for the bending mode (15) are lit (bending pipes, refer to chapter 5.2.2)
Remark:
Start button
The start button (4) on the hydraulic unit is inactive in the bending mode. The bending
operation has to be triggered with the start button (30) on the bending tool.

3.7 Removing the bending tool

• Switch off hydraulic unit on the main switch (21)
• Retract the coupling sleeve of the hydraulic coupling (1) and disconnect the
hydraulic hose (2) from the bending tool
• Disconnect the control cable (31) from the device socket (30) on the hydraulic unit
• Affix the closing cap to the device socket (30) on the hydraulic unit

3.8 De-Commissioning the hydraulic device

• Switch-off the mains switch (21)
• Pull out the mains plug (5)
Danger:
Only the original JRG Sanipex MT tools mentioned in these instructions must
be connected to the hydraulic device!
4

Maintenance

4.1 Introduction

JRG Sanipex MT tools with the exception of those checks listed below do not require
special maintenance by the user.
Remark:
Repairs
No repairs or modifications of any kind whatsoever must be carried out on the
JRG Sanipex MT tools.

4.2 Checking the hydraulic oil level

• If the oil level is so low, that it is not visible in the sight glass,
then hydraulic oil has to be replenished at the red fill opening
(maximum oil level: OK sight glass)
• For replenishing the hydraulic oil, remove the red aeration –
and venting screw plug at the oil fill opening (6) with the counter-action spanner
d16 (art. no. 4834.016). Replenish with hydraulic oil (art. no. 4839.000)
Remark:
Hydraulic oil
Only original JRG Sanipex MT hydraulic oil must be used.

4.3 Device servicing

After 70'000 operating cycles, the LED (16) „Service" lights up. In the interest of
operational safety, the complete JRG Sanipex MT tool has to be returned to the sales
point at the next opportunity for overhaul.
max
min
73