Adjusting The Cleaning Switch-Off; Setting The Jet Angle; Maintenance And Care - Franke AQCT0073 Notice De Montage Et De Mise En Service

20. Adjusting the cleaning switch-off

You can activate the cleaning switch-off with the remote control (not part of the
scope of delivery, see Accessories,
Cleaning switch-off on the fitting
20.1 Hold your hand around 10 cm from the sensor for 3 seconds.
20.2 Between the 3rd and 5th flashing of the LED, remove your hand from the range of
the sensor.
• The LED does not flash.
20.3 After between 3 and 10 seconds, hold your hand around 10 cm from the sensor
again.
20.4 Once the LED has flashed three times, remove your hand from the range of the
sensor.
• The fitting will be switched off for 3 minutes.
• The LED flashes in a 10 second cycle.
☞
If you hold your hand around 10 cm from the sensor for at least 3 seconds, the fitting
will be reactivated before the 3 minutes has expired.

21. Setting the jet angle

The jet angle can be steplessly adjusted from 13° to 23°.
21.1 Use a screwdriver to remove the stopper (a).
21.2 Use a screwdriver to adjust the jet angle.

22. Maintenance and care

The fitting must be checked and maintained at regular intervals, depending on the
water quality and in accordance with the local conditions and rules and regulations
applicable at the site.
Maintain the following components:
• Shower head (see
• Filters (see
• Non-return valve (see
Use suitable cleaning agents which do not attack the fitting in a proper manner and
rinse with water after use. High-pressure cleaners must not be used for cleaning.
Chapter 24.)
Chapter 25.)
Chapter
Chapter 31) or directly on the fitting.
29.)
- 13 -