Peg-Perego Navetta Pop-Up Notice D'emploi page 12

can then be easily repositioned in the hood when it is no
longer required.
6• COVER: place the cover over the Navetta PopUp; fasten
the buttons on both sides and the elastics as shown in the
figure.
The cover has different characteristics depending on the
collection.
The rubber bands that fasten to the hood allow the cover
to provide greater protection to the child against the
elements.
7• HANDLE: the handle is only locked in the vertical position
(Fig. a).
To lower the handle, press the two side buttons
simultaneously and push it downwards (Fig. b).
The handle is useful to carry the Navetta PopUp and fasten
it onto the chassis (Fig. c).
8• ROCKING POSITION: the base of the Navetta PopUp has
a special shape that allows you to rock your child when
placed on a flat surface.
9• SLEEPING POSITION: To turn the Navetta PopUp into a non-
rocking cradle, extract the 4 feet positioned under the base.
10• ADJUSTING THE BACKREST: thanks to the special COMFORT
SYSTEM, you can adjust the backrest into 3 positions.
Just pull the strap towards you, as shown, and position it as
you please.
11• CLOSING THE NAVETTA POPUP: The Navetta PopUp can be
closed to reduce its bulk. Press and push the tabs of the
sliders beneath the base of the Navetta PopUp (Fig. a) and
move them simultaneously towards the center of the base
(Fig. b).
12• Rotate the handle downwards, pressing the two side
buttons simultaneously (Fig. c).
Fasten the Velcro straps on both sides, to keep the Navetta
PopUp closed (Fig. d).
Ganciomatic system
13• The Ganciomatic System is a fast and practical system that
allows you to fasten the Navetta PopUp to the Ganciomatic
attachments of the stroller or chassis.
To fasten the Navetta PopUp, position it on the chassis and
press down with both hands until it clicks.
Always enable the brake on the chassis before fastening
and unfastening the bassinet.
Ensure the Navetta PopUp is properly fastened.
• To release it, pull the lever on the Ganciomatic handle
(arrow_a) and lift the Navetta PopUp.
Removing the padding
14• To remove the padding of the Navetta PopUp:
_ Unbutton the cover and remove it
_ Inside the Navetta PopUp, unbutton the two buttons
attached to the handle (Fig. a) and open the two zips as
shown in figures b and c, in order to remove the padding.
15• Lift the padding to unfasten the two sides of the strap from
the bodywork (fig d) and remove them (fig e).
16• It is also possible to remove the product's inner lining.
Padding cleaning instructions
• When washing, closely follow the instructions stated on
the label sewn into the cover.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
• Do not remove stains with solvents.
• Do not tumble dry.
Product cleaning
• This product requires a small amount of maintenance.
Cleaning and maintenance must only be carried out by
adults.
• Keep all moving parts clean and if necessary lubricate
them with light oil.
• Clean the plastic parts periodically with a damp cloth. Do
not use solvents or similar substances.
• Brush the fabric parts to remove dust.
• Protect the product from atmospheric agents: humidity,
rain or snow. Extended exposure to sunshine can cause
colour changes in many materials.
• Store the product in a dry environment.
12