Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
- English -
Start-up
Attention! The pump must never run dry.
!
Possible consequences: The pump will be destroyed.
Protective measures: Check the water level at regular intervals. Always place the unit below water level.
Attention! The installed temperature sensor automatically turns the pump off, if it is overloaded. The pump
!
automatically switches on again once the motor has cooled down. Risk of accident!
Install the unit so that it is not exposed to direct sun radiation (max. 104 ºF - 40 ºC).
Attention! Sensitive electrical components.
!
Possible consequence: The unit will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
WARNING
Risk of electric shock – This pump is supplied with a grounding conductor and grounding-type attachment plug. To
reduce the risk of electric shock, be certain that it is connected only to a properly grounded, grounding-type
receptacle.
Important:
●
The unit switches on automatically when power connection
is established.
1. Switching on: Connect power plug to the socket.
2. Turn the flow control to adjust the flow to the
fountain display.
3. Switching off: Disconnect the power plug.
Maintenance and cleaning
Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries.
Protective measures:
• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water: Isolate the
units and installations (switch off and disconnect from the power supply) before reaching into the water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
WARNING
!
This pump uses a very strong magnet to achieve superior performance. When removing the impeller assembly there
will be considerable magnetic force resisting the extraction of the impeller assembly. This is normal. Likewise when
replacing the impeller assembly there will be a strong magnetic force pulling the assembly into the pump to potentially
cause injury to fingers and in rare cases damaging the ceramic shaft or rear bearing. Use thick gloves when replacing
the impeller assembly.
Cleaning the unit
●
Never use aggressive cleaning agents or chemical solutions. These could attack the housing surface
or impair the function.
●
Recommended cleaning agent for removing stubborn limescale deposits: Vinegar and chlorine-free
household cleaning agent.
●
After cleaning, thoroughly rinse all parts in clean water.
●
Recommendation on regular cleaning. Clean the pump at least twice a year.
1.
2.
+
-
+
-
6
Publicité
Table des Matières
