Installing Your Appliance; Electrical Connection - Brandt CM4008 Guide D'installation Et D'utilisation

EN

3 INSTALLING YOUR APPLIANCE

INST
: :
Attention
Your appliance must be installed in compliance with the ins-
tructions given in this "Operating and installation instruc-
tions manual" in order to keep your food under optimum
conditions and with
INSTALLING
• Unpack the appliance.
• Remove the 4 protection pieces inserted between lid and
appliance.
• Reuse 2 of the four protection pieces that must be fitted in the
seat of the condenser plastic supports, Iocated at the rear of the
product. (see drawing here below)
This is necessary to ensure the correct distance from the wall.
• For best operation of the appliance and in order to avoid
damage when the lid is opened, leave a space of at least 7 cm
from the rear wall and 7 cm at the sides.
• Ensure that the defrosting water drainage plug is correctly posi-
tioned (5).
• The appliance should be installed in a dry, well-ventilated room.
• Avoid balconies, verandas, and patios, the excessive heat in
summer and the cold in winter could prevent your appliance from
functioning properly, or may even damage it.
• Do not place your appliance near a heat source such as an
oven or radiator.
• Your appliance has been designed for optimum functioning at a
certain ambient temperature; it is designed for a particular cli-
mate class. This climate class is clearly indicated on the identifi-
cation plate situated on the back of your appliance. Outside of
this temperature range, the performance of your appliance may
be reduced.
Climate Classe
N
ST
T
Advise:
Before placing any food in your appliance, clean it
inside and out with a bicarbonate of soda solution (1 des-
sertspoon of bicarbonate to 4 litres of water). Do not use
alcohol, scouring powder or detergents, which could
damage the surfaces. See the section on "Cleaning your
Appliance".
Check that thermostat is set to "0"
Attention:
Wait at least two hours before connecting the appliance to
the power supply in order to ensure the refrigerant circuit
is fully efficient and avoid possible rnalfunctions.
optimal energy consumption.
Ambient Temperatures
+16° to +32°C
+18° to +38°C
+18° to +43°C

ELECTRICAL CONNECTION

Attention:
For your own safety, you must comply with the instructions
given below.
Electrical installation must comply with Standard NF C *15-100,
in particular concerning the Earth.
Three-core flex 3x2.5 mm2, 230V single-phase connected to:
- 20A single-phase 230V-50Hz supply
- ELCB and an individual fuse (10 or 16A depending on the
model)
We cannot be held responsible for any incident caused by
faulty electrical installation.
Recommendations for the electrical installation of your
appliance:
• Connector characteristics: 220-230V with earth.
• Do not use extension leads, adaptors, or socket strips.
• Always make sure your circuit is earthed.
• The socket must always remain accessible, yet be out of the
reach of children.
If you have any doubts, contact your installer.
The appliance's electrical installation is earthed. For your safety,
connect the appliance to a power outlet with effective earthing (in
conformity with current electrical installation safety standards).
Your appliance is compliant with European Directives CEE/73/23
(low voltage directive), CEE/89/336 (electromagnetic compatibi-
lity) and CEE/96/57 (energy efficiency) as well as their modifica-
tions.
Attention:
Carry out an initial cleaning operation (see the section on
"Installing your appliance") before connecting your
appliance to the electrical supply. Disconnect your
appliance prior to performing any maintenance operation.
Grasp the plug directly, instead of pulling on the power
cable.
1 1 6 6