Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IV - Use of keyboard - LCD screen display
4.1 Starting
1/ In the starting up of the microphone, the LCD screen displays :
4.1.1 Factory settings
1/ Press
+
approximately 10 secondes in the starting up.
The microphone configures itself with the factory parameters.
During approximately 3 seconds, the microphone displays:
Note : Returning to factory settings will delete the last recorded
message. Archived messages are retained.
The default configuration is as follows :
- Name : BODET-MAC address
- IP configuration by DHCP
- Multicast synchronisation (broadcast)
- Synchronisation address : 239.192.55.1
- Priority : normal
- Speaker volume : level 5
- Microphone gain : normal
- User language : english
4.2 Home
When the microphone Harmonys is ready for use, the LCD
screen displayss:
4.3 Selection and deselection of broadcasting areas
The selection of zones / groups is possible only when the product is in «home» mode. Before this
stage («starting» mode), the keys are inactive.
Depending on your microphone model, the selection and deselection of the broadcast
areas are different.
4.3.1 8 zones Microphone
Press a key to make a selection. Each key is associated to a zone or a group.
It is possible to make a multiple selection by pressing several keys. This selection is retained
after the call. The assignment of the keys is done from Sigma software.
4.3.1.1 Selection of a zone/group (LED turned off)
1/ Press the key of the zone or group to be selected.
2/ The LED of the key that corresponds to the
selected zone or group is turned on.
3/ The microphone screen displays the name
of the programmed zone or group which is selected:
Note : if a another key is pressed simultaneously, the microphone only selects the first key
pressed. Then the second button is activated when first released.
BODET____
Factory
Config.
MICRO
BODET
Name zone
ON
Name group
ON
19
19
Publicité
Table des Matières
