Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.3.1.2 Deselection of a zone/group (LED turned on)
1/ Press the key of the zone or group that must be deselected
for at least 3 seconds.
2/ The LED of the key corresponding to the deselected zone or
group is turned off.
3/ The microphone screen displays the name of the
programmed zone or group which is deselected:
4.3.1.3 In case of a not set key
1/ When you press a key that is not set (not associated with a
zone or a group), the key LED remains off and the LCD
shows :
4.3.2 Multizone Microphone
4.3.2.1 Selection of a zone/group
The selection is made by dialling a 4-digit number
on the keypad corresponding to a broadcasting area.
The selection is unique.
Once the call made, the selection is reset.
The configuration of the directory is done from the
Sigma software.
To select a broadcasting area :
1/ Use the keypad to dial the 4-digit number corresponding to the area where you want to
broadcast (e.g. room A101, Building A, refectory, hall, etc.) or use the keypad's navigation
keys
and
Use the
key to make a correction in case of mistake. Press and hold for 3s to completely
erase the number entered and return to the home screen.
2/ Once the number has been dialled, the name of the corresponding broadcasting area is
displayed on the screen. If you enter a number that does not match, «Unknown» will be
displayed on the screen.
4.3.2.2 Make a General call
If the option is activated from the SIGMA software,
it is possible to make a general call by entering «0»
with the keypad. This function is activated by default.
The LCD display will show «All Zones».
4.3.2.3 Direct call
Thanks to a direct mode, it is possible to call a Harmonys speaker directly by dialling the
associated 4-digit number. Up to 4 Harmonys speaker can be called with the same number.
During a call, if at least one Harmonys is unavailable or busy,
the display shows the ratio of available Harmonys speakers.
A beep will also sounds.
While the message is playing, no sound is sent to the
Harmonys. Press and hold the key to start the broadcast.
If no Harmonys is available during a call, the message
20
20
«No Connection» is shown on the LCD screen as long
to browse inside the directory at the beginning or during entry.
Name zone
OFF
Name group
OFF
Key not
associated
1000
Name group
1001
Name zone
1111
Unknown
0
All zones
Connection
No
Connection
%%
Publicité
Table des Matières
