Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
as the broadcast key is held down. A beep will also sounds.
Note that Harmonys speakers with repeater function cannot be called directly.
4.4 Recording a message
The recording is started by pressing and holding
1/ Press
. The recording can be started only after a 3 sec.
countdown which is displayed on the microphone screen:
2/ At the end of 3 seconds speak for record the message. The
LCD screen shows:
3/ Finish recording by releasing
The LCD screen shows:
Note: when recording, the
4.5 Live vocal message and broadcast a recorded message
A live vocal message is started by pressing
a live vocal message / live broadcast state.
4.5.1 Vocal message status when no selection has been made
1/ If no selection has been made when pressing
3 seconds) no sound is broadcasted and the microphone LCD
screen displays:
4.5.2 Broadcast a LIVE vocal message on the selection
1/ When pressing
groups. The LCD screen displays:
2/ Hold* the
to broadcast a live vocal message. The LCD
screen displays:
3/ Release* the
screen displays:
* with push to talk. See Chapter 5.3.
4.5.3 Broadcast of a RECORDED message on the selection
1/ Press the
+
messages are broadcast on the selection.
The LCD screen displays:
2/ After the broadcast of the message, the LCD screen
displays, for 3 seconds:
Note: if the memory does not contain any message then the
LCD screen displays:
.
is disabled.
a jingle is played on the selected zones or
to stop the live broadcast. The LCD
. The jingle and recorded
.
. While this button is pressed, the microphone is in
(for at least
Recording
in 3s
Recording
of message
Recording
completed
No
selection
Broadcast
of jingle
Broadcast
message
Broadcast
completed
Broadcast
message
Broadcast
completed
No
message
21
21
Publicité
Table des Matières
