Assembly Instructions With Exploded Diagrams - Christopeit Sport CS 1.1 Notice De Montage Et D'utilisation

Assembly Instruction
Before beginning assembly, be sure to observe our recommenda-
tions and safety instructions.
Step 1:
Install of the front footbar (51) and the rear footbar (87) on the main
frame (56) with the carriage bolts (53), the washers 8//19 (18), spring
washer (10) and the cap nuts M8 (50).
1. Place screws (53) and two each washers (18), spring washers (10)
and nuts (50) accessibly beside the front and rear parts of the main
frame (56).
2. Insert the foot bars (51) + (87) in the holder of the main frame (56) and
adjust so that the hole patterns of the holders and the foot bars (51) +
(87) are aligned.
3. Push one screw (53) through each hole.
4. Fit the screw ends of (56) with one washer (18), spring washer (10)
and fasten each with a nut (50).
Step 2:
Connecting the computer cable harness (8) to the computer cable
harness (55), connecting lower tension cable (27) with tension con-
trol (49), installation of the support (64) on the main frame (56) with
the round-headed Allen screws M8x20 (22), the washers 8//19 (18),
and the spring washers for M8 (10).
1. Place screws (22), each washers (18) and spring washers (10) acces-
sibly beside the front part of the main frame (56).
2. Place the lower end of the support (46) against the main frame (56)
and plug the ends of the two computer cable harnesses (8) and (55)
projecting from (56) and (46) together.
(Note: The computer cable harness (8) projecting from the support (46)
must not slide into the tube, as it is required for later steps of installa-
tion.)
When joining the tubes, ensure that the cable connection is not trap-
ped.
3. Connect the middle section tension cable (49) to the bracket of lower
section cable tension (27) (See fi gure A1-A4).
4. Put one spring washer (10) and one washer (18) on each screw (22).
Push the screws (22) through the holes in the support (46), screw into
the threaded holes of the main frame (56) and tighten fi rmly.
Step 3:
Installation of the connecting tubes (23+61) at the support (46) with
washers (20+21+47), curved washer (39), spring washers (10) and
screws (26).
1. Push the washers (47), curved washers (39) and connecting tubes
(23+61) onto the shaft of the support (46).
2. Put on the screw (26) one spring washer (10), one washer (21) and one
washer (20).
3. Push the screws (26) through the threaded holes of support (46) and
tighten the connecting tubes (23+61) fi rmly.
14