Start Your Installation - NEC LCD1711M Manuel Utilisateur

Start Your Installation

Connecting the Display (Figure 8.1)
To set up this display, please refer to the following figure and procedures.
1. Be sure all equipments are off.
2. Connect the DC power cord to the power connector; plug one end of the
AC power cord into the power adapter, and then the other end into an
electrical outlet (1).
3. Connect the VGA signal cable from display VGA input connector to the
15-pin connector of your host computer and tighten the screws (2).
4. Connect the Audio-In cable from audio input port of your display to the
Audio-out port of your computer (3).
5. Turn on your computer and display.
Notice: To ensure the LCD display can work well with your computer,
please configure the display mode of your graphic card to make it
less than or equal to 1280 x 1024 resolution and make sure
timing of the display mode is compatible with the LCD display.
We have listed the "Compatibility Modes" of this LCD display in
appendices for your reference.
LCD1711M – 8