Peak performance may only be realized after the unit has been charged and discharged
for two or three times. To maintain peak performances of your cordless hand vac, it
is recommended that the unit be fully discharged, then completely recharged at least
once a month.
Charging your hand vac
Store the vacuum cleaner in the charging base when not in use so that it is always
charged and ready to use.
1. Place the charging base near an electrical power outlet.
2. Put the charging pin of the adapter into the hole at the top of the charging base
and fasten it by turning.
3. Plug the charger into a wall outlet.
4. Make sure that the on/off switch is switched off.
5. Place the unit into the charging base. The charging indicator light will light up in
green to indicate that the vacuum cleaner is properly positioned in the charging
base and that the unit is being charged. When the charging cycle is completed,
the light will shut off. However, this does not mean that you have to wait until the
appliance is fully charged before using it. After the first three times you can just
remove the appliance from the charging base whenever you need it.
ASSEMBLY
The dust filter must always be in place in the hand vac when operating the
appliance.
1. To open the dust container, push the dust container release button and remove the
dust container.
2. Verify that the dust filter is inside, then re-attach the dust container to the hand
vacuum.
3. To attach the crevice tool or the dust brush to the hand vacuum, push the
attachment into the suction hole in the front of the dust container. To attach the
motorized brush, make sure that the 2 pins of the brush piece slide into the slots in
the suction hole.
USING THE CORDLESS HAND VAC
1. Remove the hand vac from the charging base
2. To start the unit, push the on/off switch to the front, to the "on" position. To stop
the hand vac, slide the on/off switch to the back, to the "off" position.
3. A crevice tool is provided for cleaning narrow, hard to reach places. A dust brush
is provided for cleaning upholstery, furniture, etc.
41
DO211S