Operation - Beurer MP 55 Mode D'emploi

IMPORTANT
• For hygiene reasons, you should not share the attachments with anyone else.
• When switched on, the device should not come into contact with other areas of
skin (e.g. eyelashes, head hair, etc.), or with clothes or cords, to avoid injury as well
as blockages or damage to the device.
• Do not use the device on irritated skin, varicose veins, rashes, spots, (hairy)
birthmarks or wounds without consulting a doctor beforehand. The same applies
to patients with weakened immune systems, diabetes, haemophilia and immune
insufficiency.
Note
• The callus remover can be used on dry or wet skin. Removal of calluses is more
effective on dry skin.
• When used on dry skin, the skin must be completely dry and free from grease.
• Do not use any cream before removing calluses.
• Do not remove too much of a callus as it may otherwise grow back again more
strongly.

5. Operation

• Make sure that the abrasive roller is correctly inserted into the device.
• To switch on the device, move the On/Off switch to the desired speed setting.
• The LED light ensures optimal lighting conditions so that you can see and remove
calluses better.
• You can use the callus rasp at the end of the handle to pre-treat heavily callused areas of
skin on your feet.
• You can now remove severe calluses using the coarse abrasive roller
• If you wish to remove slightly callused areas or smooth your skin, use the fine callus
attachment.
• Do not use the device for longer than 3–4 seconds on one area of the skin.
• Do not use the callus remover on irritated, sore or broken skin.
• Move the device slowly and evenly over the callus. Make sure you hold the device
vertically at a 90° angle to the callus. To achieve optimum results, it may help to move the
device over the callus in different directions.
Changing the roller:
Proceed as follows to change the roller:
• Hold the callus remover in your hand as shown.
• SWith your other hand, push the roller to the left and pull it
up and off.
Changing the manual rasp:
Proceed as follows to change the rasp at the end of the
handle:
• Hold the callus remover in your hand as shown.
• Pull the protective cap off the device.
• Now pull the rasp forwards off the device.
17