Troubleshooting; Accessories - Clarke Fusion 20 Manuel D'utilisation

ENGLISH
EN

TROUBLESHOOTING

Machine Vibration
1. Pad is not centered properly.
2. Defective pad. Replace
Swirl Marks
1. Pad is too aggressive for the fl oor fi nish.
2. Pad is dirty. Check and replace.
Reduced Running Time
1. Battern needs to be charged.
2. Batteries need water. Add just enough to cover the plates in
each cell. Then charge the batteries and check the water level
again.
Pad assist machine does not pull itself (FIG. 12)
For pad assist adjustment, follow the steps below (see steps 1 - 6 in
Figure 12):
1. Tip burnisher back as shown to gain access to the pivot bracket.
2. Remove the dust bag.
3. Pull down on the dust skirt to gain access to the adjustment
hardware.
4. Lossen pivot bracket adjustment hardware and pivot bolts and
rotate bracket counterclockwise to increase pad assist.
5. Pivot braket has slots to allow adjustment.
6. Adjust pivot bracket so pad is tipped down towards the RH side
of the machine to increase the pad assist. Then retighten the
adjustment hardware.
CAUTION!
Pad assist will vary depending on the aggressiveness of pad and
the floor finish. If the deck is angled too much it could result in
the pad burning the floor on the RH side.

ACCESSORIES

-14- FORM NO. 71446A
ACCESSORIES
DESCRIPTION
Burnishing Pads - Cases of 5
Natural Blend, Tan HS 20"
Aqua 20"
Natural Blend, White HS 20"
Dust Bag - Package of 10
36V Clarke Battery Maint. System
PART NO.
976352
976240
976327
54195A
53390A
®
Clarke
Operator's Manual (EN) - FUSION 20 / 20T