Kinderkraft KOYA Guide D'utilisation page 38

2. Place the side (9) and side extension (10) on a soft surface so as not to damage the components.
The five holes of both components should be parallel. Note that both components should have
the same mark (either A or B). Slide three connectors (3) into the holes in the side extension
(10). Then insert the three screws (1) through the side (9) and screw together the two
components (Fig. G). Repeat these steps when connecting the other two components (9 & 10).
3. Position one of the sides of the cot perpendicular to one of the structures assembled in step 1.
Make sure that the ten holes in the side are facing inwards. Make sure that the wider horizontal
slat of the side (9) and side extensions (10) are facing down. Screw the side panel to the
structure using two screws (1) (Fig. B). Using two screws (1), connect the side panel to the
second headboard.
4. Attach the other side. Make sure that the ten holes of the side are facing inwards. Make sure
that the wider, horizontal side slat (9) and side extensions (10) are facing down. Screw the side
panel to the structure using four screws (1).
5. Place the bottom (11) and the bottom extension (12) with rungs upwards on a soft surface so
that the components do not get damaged. Note that there are four holes in one of the shorter
bottom slats and bottom extensions that need to be put together. Slide the four connectors (3)
into the holes in the bottom extension (12). Then put the four screws (2) through the bottom
(11) and connect the two components (fig. H).
6. Using eight screws (2), screw the extended bottom of the cot to the structure from step 4,
making sure that the mounting holes in the bottom are on the underside of the cot. Make sure
that the bottom extension (12) is on the same side as the side extensions (10). Attention! The
bottom of the cot of the dimensions of 120 x 60 cm can be adjusted to one of four selected
levels (see fig. L).
7. Mounting the wheels: use the spanner (4) to tighten the wheels (6) to the structure (fig. F). The
wheels have a locking device which must be engaged when the cot is set up in the desired
position. To engage the lock, move the lever downwards (fig. I).
8. Make sure that all connections are securely tightened. The cot of the dimensions of 120 x 60 cm
that is ready to use is shown in figure U.
9. The extended bottom of the cot is adjustable in height. To change the height of the cot, select
one of the four sets of holes which are located on the legs (7) (fig. R - I-IV) and sides, then screw
the bottom down with the screws (2) as indicated in point 6. You can place the cot on its side
(9) to adjust the height of the bottom.
V Playpen
For installation you need an Allen key (5) and a spanner (4). Mounting should
be done on a soft surface that will not damage the surface of the components.
The assembly should be carried out by two persons.
1. Screw the two legs (7a + 7b) to the headboard (8). Make sure the holes in
the components are aligned: connect the leg with the headboard where
there are only two holes. Note that there are wheel holes at the ends of
the legs. These leg ends should be at the wider (horizontal) top slat. Connect the headboard to
38